Ford Mustang (2005-2014) Owners Manual: Engine specifications
For Shelby GT500 octane requirements, see the Shelby GT500 Supplement.
Drivebelt routing
1. The short drivebelt is on the first pulley groove closest to engine.
2. The long drivebelt is on the second pulley groove farthest from engine.
3.7L V6 engine
5.0L V8 engine
...
Other materials:
Installation
Using special tool 205-054
NOTE: This is the preferred method for installing the pinion bearing
cups. If necessary, proceed to
Using special tools 205-153, 205-054, and 205-D055 in this procedure for an
alternate method.
1. Position the special tools and th ...
Installation
1. Install the spring.
1. Position the spring and spring insulator in the front suspension lower
control arm.
2. Swing the arm into the fender well.
2. Position a jack stand under the front suspension lower control arm inboard
of the spring seat
and r ...
Piston - Pin Diameter
1. Measure the piston pin diameter in two directions at the points shown.
Verify the diameter is
within specification.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
...
