Ford Mustang Service Manual: Installation

Removal

1. Raise and support the vehicle.

2. Remove the wheel and tire assembly.

3. Remove the rear brake disc (2C026).

4. Remove the differential housing cover (4033) and drain the lubricant. For additional information, refer to Differential Housing Cover in this section.

5. Remove the differential pinion shaft (4211).

1. Remove the differential pinion shaft lock bolt (4241).

2. Remove the differential pinion shaft.

6. CAUTION: Do not damage the rubber O-ring in the axle shaft groove.


6. CAUTION: Do not damage the rubber O-ring in the axle shaft groove.

Remove the U-washer (4N237).

1. Push the axle shafts (4234) inboard.

2. Remove the U-washer.

7. CAUTION: Damage to the rear brake anti-lock sensor (2C190) may occur


7. CAUTION: Damage to the rear brake anti-lock sensor (2C190) may occur if it is not removed before the axle shaft.

Carefully remove the rear brake anti-lock sensor.

8. CAUTION: Do not damage the wheel bearing oil seal.


8. CAUTION: Do not damage the wheel bearing oil seal.

Remove the axle shaft.

Installation


    Removal
    Removal 1. Raise and support the vehicle. 2. Remove the wheel and tire assembly. 3. Remove the rear brake disc (2C026). 4. Remove the differential housing cover (4033) and drain the lubricant. F ...

    Rear Wheel Bearing and Axle Shaft Oil Seal
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The diffe ...

    Other materials:

    Acceleration Control (Description and Operation)
    Acceleration Control (Description and Operation) Component Locations   The throttle is controlled by the accelerator cable which is connected to the accelerator pedal and shaft. The accelerator pedal and shaft should travel smoothly from the idle t ...

    Anti-Lock Control - Rear
    Torque Specifications Anti-Lock Control The four wheel anti-lock brake system (4WABS) consists of the following components: anti-lock brake control module (2C346) front anti-lock brake sensor (2C205) front anti-lock brake sensor indicator (2C182) ...

    Body System (Diagnosis and Testing)
    Body Sealer Types And Applications Liquid Butyl Sealer HB Fuller E709-19554-B or equivalent meeting Ford Specification ESB-M4G162-A: Does not run. Is fast drying. Remains semi-elastic. Can be used for seam sealing on the floorpan, wheelho ...