Ford Mustang Service Manual: Installation
Removal
1. Disconnect the battery ground cable (14301). For additional information, refer to Section.
2. Remove the transmission. For additional information, refer to Section.
3. Remove the air cleaner outlet tube (9B659). For additional information, refer to Section.
4. Remove the radiator sight shield (8C251).
5. Remove the manifold and tube assembly-accumulator to compressor, 4.6L. For additional information, refer to Section.
6. Remove the A/C line. For additional information, refer to Section.
7. Install the special tools.
8. Install the special tool.
9. Raise the vehicle on a hoist. For additional information, refer to Section.
10. Remove the two nuts.
11. Lower the vehicle.
12. Using the special tool, raise the engine.
13. Raise the vehicle on a hoist.
14. Remove the oil pan drain plug (6730) and drain the engine oil.
15. Using the special tool, compress the front coil springs (5310).
16. Position a safety stand.
17. Remove the four bolts.
18. NOTE
: Do not completely remove the bolts.
Loosen the bolts.
19. Lower the front sub-frame (5C145).
20. Remove the sub-frame brace.
21. Remove the starter wiring harness nuts and position the wiring harness out of the way.
22. NOTE
: Be careful when removing the oil pan gasket. It is reusable.
Remove the oil pan and gasket.
- Inspect the oil pan gasket for damage.
Removal
Removal
1. Disconnect the battery ground cable (14301). For additional information,
refer to Section.
2. Remove the transmission. For additional information, refer to Section.
3. Remove the air cle ...
Crankshaft Rear Seal with Retainer Plate
Engine (Description and Operation)
WARNING: Do not operate the engine with the hood open until the fan
blade has been first
examined for possible cracks and separation.
The 4.6L (4V) (281 CID) Cobra ...
Other materials:
Air Cleaner Outlet Pipe - 3.8L
Intake Air Distribution and Filtering - Supercharger,
Charge Air Cooler
The supercharger (SC) is a positive displacement pump. Its purpose is to
supply an excess volume of
intake air to the engine by increasing air pressure and density in the
intake man ...
Component Tests
Principles of Operation
Power Window Control
NOTE: Battery power and ground must be removed before disconnecting the
GEM connectors to
avoid setting false DTCs.
The driver power window one-touch down operation is controlled by the
generic electronic m ...
Inspection and Verification
Inspection and Verification
WARNING: A vehicle equipped with a Traction-Lok differential will
always have both
wheels driving. If, while the vehicle is being serviced, only one wheel is
raised off the ground
and the rear axle is driven by the engine, the whe ...