Ford Mustang (1999-2004) Service Manual: Installation
1. Position the side rail and install the bolts.
2. NOTE: Tighten the bottom bolt first.
Connect the mounting bracket and install the bolts.
3. NOTE: Line up the marks in the number four bow.
Tighten the bolt.
4. Connect the number two and number three bows to the side rail assembly.
5. Tighten the bolt.
6. Hand-tighten the two bolts.
7. Adjust the gap between the front of the side rail and the header to the previously recorded dimensions.
8. Tighten the bolts.
9. Connect the cable to the rear rail.
10. Attach the vinyl top cover flap to the rear rail.
11. Install the speed nut.
12. Install the headliner screws.
13. Attach the headliner pin-type retainers.
14. Install the rail seal screws.
15. Install the rail seals.
16. Install the screws and the front seal.
17. Install the speaker.
18. Install the screw.
19. Install the screw and connect the electrical connectors.
20. Position the cylinders and install the nuts.
21. Install the two cylinder rod mounting bolts.
22. Install the front safety belt retractor.
23. Install the bolts.
24. Install the side quarter trim panel.
Material
Item Specification Threadlock and Sealer E0AZ-19554-AA WSK-M2G351-A5 (type II) Shoulder Bolt Kit F5ZZ-76539A04-A - NOTE: Before starting the adjustment process, inspe ...Other materials:
Oil Level Indicator and Tube
Removal
1. Remove the oil level indicator.
2. Remove the LH exhaust manifold. For additional information, refer to Exhaust
Manifold LH in
this section.
3. Remove the bolt.
4. Remove the oil level indicator tube.
Installation
1. To install, reverse the r ...
Motor - Window Regulator
Removal
1. Remove the door trim panel. For additional information, refer to
Section.
2. Remove the screws and the speaker.
3. Disconnect the electrical connector.
4. Remove the screws and the window regulator motor.
Installation
1. To install, ...
Engine - Mach I 4.6L (4V)
General Specifications
Engine Specifications
a - Newly Installed-Refers to the condition of the "NEW" drive belt
before the engine has made no more
than one rotation and before the belt has had a chance to stretch or seat
into the pu ...