Ford Mustang (2005-2014) Owners Manual: Principles of operation

MyKey allows you to program keys with restricted driving modes to promote good driving habits. You can use all but one of the keys programmed to your vehicle with these restricted modes.

Any keys that have not been programmed are referred to as administrator keys or admin keys. These can be used to:

• create a restricted key
• program optional MyKey settings
• clear all MyKey features.

When you have programmed a MyKey, you can access the following information using the information display: • The number of admin keys and MyKeys are programmed to your vehicle.
• The total distance your vehicle has traveled using a MyKey.

Note: Switch the ignition on to use the system.

Note: All MyKeys are programmed to the same settings. You cannot program them individually.

Non-configurable Settings

The following settings cannot be changed by an admin key user : • Belt-minder. You cannot disable this feature. The audio system will mute when the front seat occupants’ safety belts are not fastened.
• Early low fuel warning. The low fuel warning is activated earlier, giving the MyKey user more time to refuel.
• Driver assist features, if equipped on your vehicle, are forced on: parking aid, blind spot information system (BLIS) with cross traffic alert, lane departure warning and forward collision warning system.

Configurable Settings

With an admin key, you can configure certain MyKey settings when you first create a MyKey and before you recycle the key or restart the vehicle. You can also change the settings afterward with an admin key.

• A vehicle speed limit can be set. Warnings will be shown in the display followed by an audible tone when your vehicle reaches the set speed.

You cannot override the set speed by fully depressing the accelerator pedal or by setting cruise control.
• Vehicle speed minders of 45, 55 or 65 mph (75, 90 or 105 km/h).

Once you select a speed, it will be shown in the display, followed by an audible tone when the preselected vehicle speed is exceeded.
• Audio system maximum volume of 45%. A message will be shown in the display when you attempt to exceed the limited volume. Also, the speed-sensitive or compensated automatic volume control will be disabled.
• Always on setting. When this is selected, you will not be able to turn off AdvanceTrac (if your vehicle is equipped with this feature).

    MyKey
    ...

    Creating a MyKey
    Use the information display to create a MyKey. For Type 1 information displays: 1. Insert the key you want to program into the ignition. 2. Switch the ignition on. 3. Access the main menu within the ...

    Other materials:

    Pinpoint Tests
    CAUTION: Before removing and installing the GEM or its connectors, disconnect the battery. Failure to follow this caution will result in the GEM storing many erroneous DTCs and may result in the GEM exhibiting erratic operation after installation. CAUTI ...

    Pinpoint Test C: LFC 29/DTC C1414 - Incorrect Vehicle Identification Code
    Normal Operation The restraints control module (RCM) monitors the electrical state of pins 10, 13 and 14 to determine if it is installed on the correct vehicle. If the RCM detects an incorrect condition on any of these pins, it will store a diagnostic t ...

    Starter Drive and Flywheel Ring Gear Inspection
    1. Remove the starter motor. For additional information, refer to Starter Motor-3.8L or Starter Motor-4.6L in this section. 2. Check the wear patterns on the starter drive gear and the flywheel ring gear . If the wear pattern is normal, install the sta ...