Ford Mustang Service Manual: Removal
Removal
1. Disconnect the battery ground cable (14301). For additional information, refer to Section.
2. Remove the transmission. For additional information, refer to Section.
3. Remove the air cleaner outlet tube (9B659). For additional information, refer to Section.
4. Remove the radiator sight shield (8C251).
5. Remove the manifold and tube assembly-accumulator to compressor, 4.6L. For additional information, refer to Section.
6. Remove the A/C line. For additional information, refer to Section.
7. Install the special tools.
8. Install the special tool.
9. Raise the vehicle on a hoist. For additional information, refer to Section.
10. Remove the two nuts.
11. Lower the vehicle.
12. Using the special tool, raise the engine.
13. Raise the vehicle on a hoist.
14. Remove the oil pan drain plug (6730) and drain the engine oil.
15. Using the special tool, compress the front coil springs (5310).
16. Position a safety stand.
17. Remove the four bolts.
18. NOTE
: Do not completely remove the bolts.
Loosen the bolts.
19. Lower the front sub-frame (5C145).
20. Remove the sub-frame brace.
21. Remove the starter wiring harness nuts and position the wiring harness out of the way.
22. NOTE
: Be careful when removing the oil pan gasket. It is reusable.
Remove the oil pan and gasket.
- Inspect the oil pan gasket for damage.
Oil Pan
Engine (Description and Operation)
WARNING: Do not operate the engine with the hood open until the fan
blade has been first
examined for possible cracks and separation.
The 4.6L (4V) (281 CID) Cobra ...
Installation
Removal
1. Disconnect the battery ground cable (14301). For additional information,
refer to Section.
2. Remove the transmission. For additional information, refer to Section.
3. Remove the air cle ...
Other materials:
Component Tests
Inspection and Verification
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid ...
Instrument Panel and Console
Torque Specifications
Instrument Panel
The instrument panel consists of the following components:
instrument cluster
instrument panel finish panels
audio unit
A/C controls
glove compartment door
passenger air bag module
glove compart ...
Transmission (INSTALLATION)
Transmission Description (Description and Operation)
The 4R70W has the following features:
Wide ratio gears
Four speeds
Rear wheel drive
Automatic
Electronic shift
Torque converter clutch control
Line pressure controls
The transm ...