Ford Mustang (1999-2004) Service Manual: Transmission Cooling - Integral
This vehicle with an automatic transmission is equipped with an integral transmission fluid cooler. The cooler is contained inside of the radiator outlet tank and cannot be serviced separately. The cooler transfers heat from the transmission fluid to the engine coolant.
For transmission fluid cooler flow test, refer to Section.
For transmmission fluid cooler backflushing and cleaning, refer to Section.
Transmission Fluid Cooler Tubes
Transaxle/Transmission Cooling
General Specifications
Torque Specifications
...
Transmission Cooling
Inspection and Verification
WARNING: Never remove the radiator cap under any conditions while the engine
is
operating. Failure to follow these instructions could result in personal injury
and/or dam ...
Other materials:
Rear Drive Axle/Differential - Ford 8.8-Inch IRS
General Specifications
Torque Specifications
a: Use Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford
specification WSKM2G349-
A1.
b: With pinion flange yoke seal. ...
Assembly
1. Install the locking lever cam and pin.
2. Install the lock actuator lever and pin.
3. Install the lock actuator lever return spring.
4. Install the ignition lock cylinder lockout lever.
5. NOTE: The lock lever with two teeth is installed on the left ...
Washer fluid check
WARNING: If you operate your vehicle in temperatures below
40°F (5°C), use washer fluid with antifreeze protection. Failure
to use washer fluid with antifreeze protection in cold weather could
result in impaired windshield vision and increase the risk of inj ...
