Ford Mustang (2005-2014) Owners Manual: Vehicle certification label

The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certification Label may be located.

The Safety Compliance Certification Label shall be affixed to either the door hinge pillar, the door latch post, or the edge of the door near the door latch, next to the driver’s seating position.

    Vehicle identification number
    The vehicle identification number is located on the driver’s side instrument panel. Please note that in the graphic, XXXX is representative of your vehicle identification number. The Vehicle Ident ...

    Transmission code designation
    You can find a transmission code on the Safety Compliance Certification Label. The following table tells you which transmission each code represents. ...

    Other materials:

    Installation
    LH mount 1. Position the engine mount and install the bolt and studbolts. 2. Attach the ground cables and install the nuts. RH mount 3. Position the engine mount and install the bolts and studbolt. 4. Attach the wiring harness and install the nut. Both ...

    General Information
    INTRODUCTION In the past, when cars were simpler, diagrams were simpler. All components were connected by wires, and diagrams seldom exceeded 4 pages in length. Today, some wiring diagrams require more than 16 pages. It would be impractical to expect a servi ...

    Wheel Bearing Check
    1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch. Failure to do so can result in unexpected infla ...