Ford Mustang (2005-2014) Owners Manual: Windshield washers

Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out.

Always use the windshield washer before wiping a dry windshield.

Note: Do not operate the washer when the washer reservoir is empty.

This may cause the washer pump to overheat.

Press the end of the stalk to activate the washer.

• A brief press causes a single wipe without washer fluid.
• A quick press and hold causes the wipers to swipe three times with washer fluid.
• A long press and hold will activate the wipers and washer fluid for up to 10 seconds.

A wipe will occur a few seconds after washing to clear any remaining washer fluid.

    Windshield wipers
    Note: Fully defrost the windshield before switching on the windshield wipers. Note: Make sure you switch off the windshield wipers before entering a car wash. Note: Clean the windshield and wiper bl ...

    Lighting
    ...

    Other materials:

    Valve Cover - LH
    Removal and Installation 1. Position the ignition wires (12281) aside. 2. Disconnect the positive crankcase ventilation (PCV) valve (6758). 3. Remove the ignition coil and position aside. 1. Disconnect the electrical connector. 2. Disconnect the ac ...

    Engine Dynamic Balance Shaft
    Removal 1. Remove the timing chain (6268). For additional information, refer to Timing Chain in this section. 2. Disconnect and position the wire harness aside. 3. Remove the radiator fan and shroud assembly (8146). 4. Remove the engine dynamic balan ...

    Horn (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 44 , Horns/Cigar Lighter for schematic and connector information. Special Tool(s) 73 Digital Multimeter or equivalent 105-R0051 Inspection and Verification 1. Verify the customer concern by operating the h ...