Ford Mustang (1993-2004) Service Manual: Crankshaft Rear Oil Seal (4.6L)

Engine

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A modular engine is built around four modules:

 

A modular engine is built around four modules:

  • the intake module
  • the cylinder head module (RH)
  • the cylinder head module (LH)
  • the lower engine module

While not all repairs can take advantage of the modular concept, most out-of-vehicle repairs benefit due to the reduction of necessary time and labor.

The basic engine components consist of the following:

  • single overhead camshafts
  • two valves per cylinder
  • sequential multiport fuel injection (SFI)
  • aluminum cylinder heads (6049)
  • cast iron, 90-degree V-shaped cylinder block
  • individual ignition coils for each spark plug
  • composite-material intake manifold
  • large-bore throttle body

Engine (DIAGNOSIS AND TESTING)

For basic mechanical concerns, refer to Section. Refer to the Powertrain Control/Emissions Diagnosis (PC/ED) manual.

    Flexplate (4.6L)
    Engine                         A modular engine is built around four modules: the intake module t ...

    Other materials:

    Inspection and Verification
    Principles of Operation NOTE: Battery power and ground must be remove before disconnecting the GEM connectors to avoid setting false codes. Power Locks Operation The power locks feature allows the customer to lock and unlock the doors via momenta ...

    Bushing - Stabilizer Bar
    Wheel Studs Removal 1. Remove the wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section. 2. Using a press, remove the wheel stud (1107) from the wheel hub. Installation 1. Using a press, install a new wheel stud. 2. I ...

    Differential Case and Ring Gear
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket. ...