Ford Mustang (2005-2014) Owners Manual: Universal Garage Door Opener (If Equipped)
UNIVERSAL GARAGE DOOR OPENER
The appearance of your vehicle’s universal garage door opener will vary according to your option package. Before programing, make sure you identify which transmitter you have by comparing it to the graphics below.
HomeLink®
Car2U® Home Automation System
Note: The programming of the two types of universal garage door openers are different and have different instructions. Identify your package and refer to the instructions listed in this chapter.
Rear seats
Rear Seat Entry and Exit
Use the seatback release to fold the
back of the front seat forward for
rear seat access. This release handle
is located on the upper back of the
front seat. The seatback loc ...
Car2U® home automation system
WARNING: Make sure that the garage door and security device
are free from obstruction when you are programming. Do not
program the system with the vehicle in the garage.
WARNING: Do not use the system ...
Other materials:
Engine (Disassembly)
Special Tool(s)
Impact Slide Hammer
100-001 (T50T-100-A)
Remover, Crankshaft Vibration
Damper
303-009 (T58P-6316-D)
Holding Tool, Crankshaft
303-448 (T93P-6303-A)
Guides, Connecting Rod
303-442 (T93P- ...
Wheel And Tire
Removal
1. CAUTION: Do not use heat to loosen a seized wheel nut (1012). Heat
can damage
the wheel and wheel bearings.
NOTE: To avoid damage or scratching to the center cap, place facing up
when removed.
Loosen the wheel nuts.
1. NOTE: To avoid wheel damag ...
Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the output shaft speed (OSS) sensor.
4. To install, reverse the removal procedure. ...
