Ford Mustang (1999-2004) Service Manual: 1-2 Accumulator
Removal
1. Compress the 1-2 accumulator cover and remove the accumulator piston retaining ring.
2. NOTE: Note the location of the 1-2 accumulator springs for reference during assembly.
Remove the 1-2 accumulator.
1. Remove the 1-2 accumulator cover.
2. Remove the lower 1-2 accumulator spring.
3. Remove the accumulator piston.
4. Remove the upper 1-2 accumulator spring.
Installation
1. Install the 1-2 accumulator.
1. Install the 1-2 accumulator upper spring.
2. Install the accumulator piston.
3. Install the 1-2 accumulator lower spring.
4. Install the cover and seal assembly.
2. Compress the accumulator and install the accumulator piston retaining ring.
Overdrive Servo
Special Tool(s) Remover/Installer, Servo Piston 307-251 (T92P-70023-A) Removal 1. Remove the main control valve body. For additional information, refer to Main Control Valve Body ...2-3 Accumulator
Removal 1. Remove the main control valve body. For additional information, refer to Main Control Valve Body in this section. 2. Remove the 2-3 accumulator piston retainer. 3. Remove the accumulato ...Other materials:
Inspection and Verification
1. Verify the customer concern by operating the wiper/washer system.
2. Visually inspect for obvious signs of mechanical and electrical
damage.
Visual Inspection Chart
Mechanical
Electrical
Hoses to windshield washer pump
Wiper l ...
Front Subframe - 4.6L (2V) Engine
Special Tool(s)
Support Bar, Engine
303-290-A
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Removal and Installation
All vehicles
1. Remove the steering gear. For additional information, refer to Section.
2. Remove the lower co ...
Engine Mount LH
Special Tool(s)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Support Bar, Engine
303-290-A
Removal
1. Install the special tool.
2. Install the special tools.
3. Raise and support the vehicle. For additional information, ref ...