Ford Mustang (1999-2004) Service Manual: Acceleration Control (Description and Operation)
Component Locations
The throttle is controlled by the accelerator cable which is connected to the accelerator pedal and shaft.
- The accelerator pedal and shaft should travel smoothly from the idle to the wide-open throttle (WOT) positions. Hesitation on return or prevention of return to the idle position must not occur.
- Surrounding components such as wiring, hoses, sound insulator and floor covering must not contact the sliding inner member of the accelerator cable or the accelerator pedal and shaft.
- The sliding inner member of the accelerator cable should not be lubricated and is not serviceable.
Acceleration Control (Diagnosis and Testing)
Inspection and Verification 1. Verify the customer's concern by operating the acceleration control system to duplicate the condition. 2. Inspect to determine if any of the following mechanical conce ...Other materials:
Exhaust Manifold to Exhaust Gas Recirculation (EGR)
Valve Tube
Removal and Installation
NOTE: 3.8L shown, 4.6L (2V) similar.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the exhaust gas recirculation (EGR) valve tube from the
exhaust manifold.
3. Remove the differential feedback exhaust ga ...
Input Shaft and Bearing
Special Tool(s)
Remover, Driver Pinion
Bearing Cone
205-D002 (D79L-4621-A) or
equivalent
Installer, Drive Pinion Bearing
Cone
205-011 (T57L-4621-B)
Remover/Installer, Bearing
Tube
308-024 (T75L-7025-B)
Disas ...
Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket.
For additional
information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the
throttle body full open
and align ...