Ford Mustang (1999-2004) Service Manual: Accelerator Cable - 3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open and aligning the cable with the release slot.
4. Disconnect the accelerator cable from the retaining bracket by compressing the locking tabs and back-feeding the cable through the bracket and out of the engine compartment.
5. To install, reverse the removal procedure.
Accelerator Pedal and Shaft
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Remove the accelerator pedal and shaft. Remove the nuts. Remove the accelerato ...Accelerator Cable - 4.6L (2V)
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Remove the bolts retaining the accelerator cable to the dash panel. 3. Disconne ...Other materials:
Cleaning the windows and wiper blades
The windows and wiper blades should be cleaned regularly. If the wipers
do not wipe properly, substances on the vehicle’s glass or the wiper
blades may be the cause. These may include hot wax treatments used by
commercial car washes, water repellent coatings ...
Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw.
5. Release the clips.
1. Lift up to release the two ...
Generator - 3.8L
Removal and Installation
1. Disconnect the battery (10655). For additional information, refer
to Section.
2. Relieve the accessory drive belt (8620) tension and remove the belt
from the generator pulley.
Leave the belt in place for reinstallation ...