Ford Mustang (1999-2004) Service Manual: Accelerator Cable - 4.6L (2V)
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open and aligning the cable with the release slot.
4. Disconnect the accelerator cable from the retaining bracket by compressing the locking tabs and back-feeding the cable through the bracket and out of the engine compartment.
5. To install, reverse the removal procedure.
Accelerator Cable - 3.8L
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Remove the bolts retaining the accelerator cable to the dash panel. 3. Disconne ...Accelerator Cable - Supercharged Engine
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Disconnect the accelerator cable from the throttle cam. 3. Depress the tabs and ...Other materials:
Installation
1. Position the wiring harness:
Install the wiring harness retainer onto the LH valve cover stud bolt.
Install the wiring harness retainer into the power steering reservoir.
2. Connect the ECT sensor electrical connector.
3. Connect the CMP senso ...
Appendices
GENERAL INFORMATION
SYNC® End User License Agreement (EULA)
• You have acquired a device (“DEVICE”) that includes software
licensed by FORD MOTOR COMPANY from an affiliate of Microsoft
Corporation (“MS”). Those installed software products of MS orig ...
Input Shaft and Bearing
Special Tool(s)
Input Shaft Seal Replacer
308-220 (T94P-7025-AH)
Pinion Bearing Cone Remover
205-D002 (D79L-4621-A) or
Equivalent
Disassembly
1. Using the special tool and a press, remove the input bearing (7025).
2. Remove t ...