Ford Mustang (1999-2004) Service Manual: Accelerator Cable Bracket - 3.8L
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket. For additional information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open and aligning the cable with the release slot.
3. Compress the accelerator cable locking tabs and disconnect the accelerator cable from the accelerator cable bracket.
4. Remove the bolts and the accelerator cable bracket.
5. To install, reverse the removal procedure.
Accelerator Cable - Supercharged Engine
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Disconnect the accelerator cable from the throttle cam. 3. Depress the tabs and ...Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation 1. Disconnect the speed control cable from the throttle body and the bracket. For additional information, refer to Section. 2. Disconnect the accelerator cable from the thro ...Other materials:
Cleaning
1. Fabricate a cleaning tool from a 1/8 inch diameter brazing rod.
2. Cut an abrasive pad from maroon colored 3M Scotch Brite with the
dimensions corresponding
to the coupling size.
3. Assemble the pad to the tool.
4. Coat the abrasive pad with PAG Refri ...
Crankshaft Position (CKP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the crankshaft position (CKP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse ...
Starter Motor - 3.8L
Removal
WARNING: When servicing starter motor (11002) or carrying out other
underhood work in
the vicinity of the starter motor, be aware that the heavy gauge battery
input lead at the starter
solenoid (11390) is "electrically hot" at all times. A prote ...