Ford Mustang (1999-2004) Service Manual: Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket. For additional information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open and aligning the cable with the release slot.
3. Compress the accelerator cable locking tabs and disconnect the accelerator cable from the accelerator cable bracket.
4. Remove the spring.
5. Remove the bolts and the accelerator cable bracket.
6. To install, reverse the removal procedure.
Accelerator Cable Bracket - 3.8L
Removal and Installation 1. Disconnect the speed control cable from the throttle body and the bracket. For additional information, refer to Section. 2. Disconnect the accelerator cable from the thro ...Accelerator Cable Bracket - Supercharged Engine
Removal and Installation 1. Disconnect the accelerator cable and speed control cable. 2. Depress the tabs and disconnect the accelerator cable and speed control cable from the accelerator cable bra ...Other materials:
Disassembly
1. Remove the retaining ring above fifth gear.
2. CAUTION: Hand tighten the special tool to prevent gear damage.
CAUTION: Support the output shaft while using the press to prevent
damage to the
shaft or gears.
Using the special tool, press fifth gear, the s ...
Manual Transaxle/Transmission - T56
General Specifications
Torque Specifications
...
Antenna
Torque Specifications
Antenna
The antenna system consists of:
antenna mast
antenna base and cable
antenna lead-in cable
The radio antenna uses a two-piece coaxial cable to connect the audio
unit to the antenna. The front
antenna lead-i ...