Ford Mustang (1999-2004) Service Manual: Accelerator Pedal and Shaft
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
2. Remove the accelerator pedal and shaft.
- Remove the nuts.
- Remove the accelerator pedal and shaft.
3. To install, reverse the removal procedure.
Acceleration Control (Diagnosis and Testing)
Inspection and Verification 1. Verify the customer's concern by operating the acceleration control system to duplicate the condition. 2. Inspect to determine if any of the following mechanical conce ...Accelerator Cable - 3.8L
Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Remove the bolts retaining the accelerator cable to the dash panel. 3. Disconne ...Other materials:
Supercharger Cooling
General Specifications
a - Use the same type coolant that was drained from the cooling system.
Do not mix coolant types.
b - The addition of Motorcraft Cooling System Stop Leak Pellets, VC-6,
darkens Motorcraft Premium
Gold Engine Coolant from yell ...
Disc and Pressure Plate - 3.8L and 4.6L (2V) Engines
Special Tool(s)
Clutch Aligner
308-020 (T74P-7137-K)
Material
Item
Specification
Premium Long Life Grease
XG-1-C
ESA-M1C75-B
1. Remove the transmission.
2. CAUTION: Loosen the bolts evenly to prevent clutch pressure plate
...
Driveshaft (Description and Operation)
NOTE: All driveshaft assemblies are balanced. If undercoating the
vehicle, protect the driveshaft to
prevent overspray of any undercoating material.
The driveshaft has the following features:
A tubular shaft used to transfer engine torque from the ...