Ford Mustang (1999-2004) Service Manual: Accessory Drive Belt - 3.8L
Removal and Installation
1. Rotate the drive belt tensioner counterclockwise and remove the drive belt.
2. NOTE: Make sure the drive belt is correctly installed on each pulley.
To install, reverse the removal procedure.
- Refer to Accessory Drive for drive belt routing.
Component Tests
Drive Belt Noise/Flutter Drive belt chirp occurs due to pulley misalignment or excessive pulley runout. It can be the result of a damaged pulley or an incorrectly aligned pulley. To correct, determi ...Accessory Drive Belt - 4.6L (2V) and (4V)
Removal and Installation Mach I 1. Remove the air intake scoop. For additional information, refer to Section. Cobra 2. Remove the supercharger drive belt cover. 3. Rotate the supercharger belt tensi ...Other materials:
Disassembly
1. Remove the driveshaft (4602). For additional information, refer to
Driveshaft in this section.
2. CAUTION: Under no circumstances is the driveshaft assembly to be
clamped in the
jaws of a vise or similar holding fixture. Denting or localizing fracture ca ...
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if installation becomes necessary. ...
Floor Console
Removal and Installation
All vehicles
1. Disconnect the battery ground cable. For additional information,
refer to Section .
2. Apply the parking brake.
Vehicles with automatic transmission
3. Place the selector lever in the 1 position.
Vehicle ...