Ford Mustang (1999-2004) Service Manual: Accessory Drive Belt Tensioner - 4.6L (2V) and (4V)
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt.
4. Remove the cooling hose and tube assembly mounting bolt.
5. Remove the belt idler support bracket assembly.
6. Remove the accessory drive belt. For additional information, refer to Accessory Drive Belt- 4.6L (2V) and (4V) in this section.
7. Remove the accessory drive belt tensioner.
All engines
8. Remove the accessory drive belt. For additional information, refer to Accessory Drive Belt Tensioner-4.6L (2V) and (4V) in this section.
9. Remove the belt tensioner.
- Remove the bolt and the tensioner.
10. To install, reverse the removal procedure. Refer to Accessory Drive and Accessory Drive- Cobra for accessory drive belt routing.
Accessory Drive Belt Tensioner - 3.8L
Removal and Installation 1. Remove the drive belt. For additional information, refer to Accessory Drive Belt-3.8L in this section. 2. Remove the belt tensioner. Remove the bolt. 3. To install, ...Supercharger Belt Tensioner
Removal and Installation 1. Remove the supercharger drive belt cover. 2. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt. 3. Remove the bolts and the supercharger ...Other materials:
Gear (Removal and Installation)
Special Tool(s)
Teflon Seal Replacer Set
211-D027 (D90P-3517-A) or
Equivalent
Tie Rod End Remover
211-001 (TOOL-3290-D)
Removal
1. Turn the steering wheel as necessary to position the wheels in the
straight-ahead position. Do
not loc ...
Parking Brake Control
Removal
1. CAUTION: If any component in the parking brake system requires
repair or if the
rear axle housing (4010) is removed, the cable tension must be released.
Place the parking brake control (2780) in the released position.
2. Remove the console.
3. ...
Accelerator Cable - Supercharged Engine
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Disconnect the accelerator cable from the throttle cam.
3. Depress the tabs and disconnect the accelerator cable from the bracket.
4. Rel ...