Ford Mustang (1999-2004) Service Manual: Actuator Cable - Speed Control-Cobra
1. Remove the speed control actuator cable end from the throttle body.
1. Lift the speed control cable from the throttle nailhead.
2. Release the speed control cable from the throttle bracket.
2. Remove the speed control cable from the retaining clips.
3. Remove the LH front wheel and tire assembly. For additional information, refer to Section
4. Position aside the LH front splash shield.
- Remove the pin-type retainers.
- Remove the screws.
5. Depress the locking tab and rotate the speed control actuator cable cap to remove.
6. Gently push in the retaining spring while disconnecting the speed control actuator cable from the speed control actuator pulley.
Installation
1. To install, reverse the removal procedure.
Actuator Cable - Speed Control
1. Remove the speed control actuator cable end from the throttle body. 1. Lift the speed control cable from the throttle nailhead. 2. Release the speed control cable from the throttle bracket. ...Actuator - Speed Control Servo
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result. Disconnect the battery ground cable. 2. Remove the LH wheel and tire; re ...Other materials:
Antenna (Removal and Installation)
Removal
1. Lower the glove compartment by releasing the stops from the
instrument panel.
2. Disconnect the antenna in-line connector
3. Remove the antenna base and cable.
1. Remove the radio antenna base cap.
2. Remove the screws.
3. Re ...
Inspection and Verification
Certain axle noise or vibration symptoms are also common to the engine,
transmission, wheel
bearings, tires, and other parts of the vehicle. For this reason, be sure that
the cause of the trouble is
in the axle before disassembling, adjusting or repairing th ...
Catalyst Monitor Sensor
Special Tool(s)
Socket, Exhaust Gas Oxygen
Sensor
303-476 (T94P-9472-A)
Material
Item
Specification
Penetrating and Lock Lubricant
or equivalent
E8AZ-19A501-
B
Removal and Installation
1. Disconnect the battery ground ...