Ford Mustang (1999-2004) Service Manual: Air Conditioning (A/C) Compressor - 3.8L
Material
Item | Specification |
PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) | WSH-M1C231- B |
Removal and Installation
CAUTION: If installing a new air conditioning compressor due to an internal failure of the old unit, you must carry out the following procedures to remove contamination from the air conditioning system.
- If A/C flushing equipment is available, carry out the flushing of the air conditioning system prior to installing a new air conditioning compressor. For additional information, refer to Section.
- If A/C flushing equipment is not available, carry out filtering of the air conditioning system after a new air conditioning compressor has been installed. For additional information, refer to Section.
- Install a new evaporator core orifice (19D990), as directed by the A/C flushing or filtering procedure.
- Install a new suction accumulator (19C836), as directed by the A/C flushing or filtering procedure.
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of system contamination from a failed A/C compressor or damage to the suction accumulator.
1. If flushing of the air conditioning system has not been performed, recover the refrigerant. For additional information, refer to Section.
2. Disconnect the battery. For additional information, refer to Section.
3. Unlatch the air breather.
4. Disconnect the mass airflow (MAF) sensor electrical connector.
5. Remove the air cleaner outlet tube (9B659).
1. Loosen the clamp.
2. Disconnect the crankcase ventilation tube (6758).
3. Remove the air cleaner outlet tube assembly.
6. Remove the drive belt (8620) from the A/C compressor pulley.
7. Disconnect the electrical compressor clutch connector.
8. Remove the bolt and disconnect the A/C manifold and tube (19D734).
- Discard the O-ring seals.
9. Remove the bolts and the A/C compressor.
10. To install, reverse the removal procedure.
- Install new O-ring seals lubricated in clean PAG oil.
- If filtering of the refrigerant system is not to be performed, lubricate the refrigerant system with the correct amount of clean PAG oil. For additional information, refer to Section.
11. If filtering of the air conditioning system is not to be performed, evacuate, leak test and charge the refrigerant system. For additional information, refer to Section.
Spring Lock Coupling
The spring lock coupling is a refrigerant line coupling held together by a garter spring inside a circular cage. When the coupling is connected together, the flared end of the female f ...Air Conditioning (A/C) Compressor - 4.6L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation CAUTION: If installing ...Other materials:
Driveshaft (Description and Operation)
NOTE: All driveshaft assemblies are balanced. If undercoating the
vehicle, protect the driveshaft to
prevent overspray of any undercoating material.
The driveshaft has the following features:
A tubular shaft used to transfer engine torque from the ...
Engine Ignition (Description and Operation)
The ignition coil (12029), which is mounted on the upper intake manifold, can
be described as a coil
pack containing three separate coil units. Each coil unit is individually
controlled by the powertrain
control module (PCM) (12A650) through separate wire le ...
Using the boot
Installing the Boot
WARNING: Always secure the retaining clips and boot straps on
the vehicle or the boot may come loose while driving.
Note: Be sure the boot is secure on the vehicle before driving.
Improper
installation can result in loss or damage of the b ...