Ford Mustang (1999-2004) Service Manual: Air Conditioning (A/C) Pressure Relief Valve - 3.8L
Material
Item | Specification |
PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) | WSH-M1C231- B |
Removal and Installation
1. Recover the refrigerant. For additional information, refer to Section.
2. Unlatch the breather.
3. Disconnect the mass air flow (MAF) sensor electrical connector.
4. Remove the air cleaner outlet tube.
1. Loosen the clamp.
2. Disconnect the crankcase ventilation tube.
3. Remove the air cleaner outlet tube.
5. Remove the A/C compressor pressure relief valve.
- Discard the O-ring seal.
6. To install, reverse the removal procedure.
- Install a new O-ring seal lubricated in clean PAG oil.
7. Evacuate, leak test and charge the refrigerant system. For additional information, refer to Section.
Suction Accumulator
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation 1. Recover the refriger ...Air Conditioning (A/C) Pressure Relief Valve - 4.6L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a ...Other materials:
Vehicle identification number
The vehicle identification number
is located on the driver’s side
instrument panel.
Please note that in the graphic,
XXXX is representative of your
vehicle identification number.
The Vehicle Identification Number (VIN) contains the following
information:
...
Refueling
WARNING: Fuel vapor burns violently and a fuel fire can cause
severe injuries. To help avoid injuries to you and others:
• Read and follow all the instructions on the pump island.
• Turn off your engine when you are refueling.
• Do not smoke if you are n ...
Axle Housing Casting Porosity (Holes in Casting) Repair
CAUTION: To keep the axle's sound characteristics, do not disassemble
the carrier.
NOTE: Casting porosity is a condition where occasionally gas bubbles will
form during the casting
process leaving small pockets in the metal that will cause the axle housing t ...