Ford Mustang (1999-2004) Service Manual: Air Intake Scoop Bracket
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to Air Intake Scoop in this section.
2. Remove the air intake scoop bracket nut at the throttle body.
3. Remove the exhaust gas recirculation (EGR) vacuum regulator solenoid bolts and position the EGR vacuum regulator solenoid aside.
4. Remove the air intake scoop bracket nuts and the air intake scoop bracket bolt and remove the air intake scoop bracket from the engine.
5. To install, reverse the removal procedure.
Air Intake Scoop
Removal and Installation 1. Disconnect the air intake scoop outlet from the air cleaner. 2. Disconnect the air intake scoop water drain hoses. 3. Remove the air intake scoop from the air intake s ...Charge Air Cooler
Material Item Specification Silicone Gasket and Sealant F7AZ-19554-EA or equivalent WSE-M4G323-EA Removal and Installation 1. Drain the supercharger coolant. For additional inform ...Other materials:
Driveshaft (Description and Operation)
NOTE: All driveshaft assemblies are balanced. If undercoating the
vehicle, protect the driveshaft to
prevent overspray of any undercoating material.
The driveshaft has the following features:
A tubular shaft used to transfer engine torque from the ...
Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously
- RCM
Disconnected, Inoperative or Lost/Low Ignition Feed
Normal Operation
NOTE: During normal operation the air bag indicator will be lit continuously
for 6 seconds after the
ignition switch is placed in the RUN position and after five cycles of a lamp
fault code (LFC) if a fault
exists. Be sure to cycle the ignit ...
Disc and Pressure Plate - 3.8L and 4.6L (2V) Engines
Special Tool(s)
Clutch Aligner
308-020 (T74P-7137-K)
Material
Item
Specification
Premium Long Life Grease
XG-1-C
ESA-M1C75-B
1. Remove the transmission.
2. CAUTION: Loosen the bolts evenly to prevent clutch pressure plate
...