Ford Mustang (1999-2004) Service Manual: Antenna (Removal and Installation)
Removal
1. Lower the glove compartment by releasing the stops from the instrument panel.
2. Disconnect the antenna in-line connector
3. Remove the antenna base and cable.
1. Remove the radio antenna base cap.
2. Remove the screws.
3. Remove the antenna base and cable.
- Disconnect the antenna cable grommet.
Installation
1. To install, reverse the removal procedure.
Antenna
Torque Specifications
Antenna
The antenna system consists of:
antenna mast
antenna base and cable
antenna lead-in cable
The radio antenna uses a two-piece coaxial cable to connect ...
Cable - Antenna Lead In
Removal
1. Remove the audio unit. Refer to Section.
2. Lower the glove compartment by releasing the stops from the
instrument panel.
3. Disconnect the antenna in-line connector.
4. Remove ...
Other materials:
Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously
- RCM
Disconnected, Inoperative or Lost/Low Ignition Feed
Normal Operation
NOTE: During normal operation the air bag indicator will be lit continuously
for 6 seconds after the
ignition switch is placed in the RUN position and after five cycles of a lamp
fault code (LFC) if a fault
exists. Be sure to cycle the ignit ...
Removal
1. Remove the roller followers. For additional information, refer to Roller
Followers in this section.
2. Remove the LH timing chain for the LH side and both timing chains for the RH
side. For
additional information, refer to Timing Drive Components in this ...
Cylinder Heads (Removal)
Special Tool(s)
Remover, Crankshaft Vibration
Damper
303-009 (T58P-6316-D)
Remover, Crankshaft Front Oil
Seal
303-107 (T74P-6700-A)
Engine Lift Bracket Set
303-DS086 (D93P-6001-A)
Compressor, Valve Sprin ...
