Ford Mustang (1999-2004) Service Manual: Assembly
1. Lubricate all components with the recommended transmission fluid when reassembling.
2. Using the special tools, press the output shaft front bearing on the output shaft.
3. Install the third gear bearing.
- Apply petroleum jelly to the bearing.
4. Install third gear, the third gear synchronizer blocking ring and the third/fourth gear synchronizer assembly. Position the output shaft with the output end facing upward. Using the special tool, press the third/fourth gear synchronizer assembly into place.
- Install the synchronizer body with the groove facing third gear.
- Stop press operation before keys engage the blocking ring slots. Lift and rotate the third gear and the blocking ring until the keys are seated in the blocking ring.
5. Install a new snap ring.
6. Install the second gear needle bearing.
- Apply petroleum jelly to the bearing.
7. Install second gear.
8. Install the second gear synchronizer thrust washer, the inner cone, the friction cone and the second gear synchronizer blocking ring.
- Align the blocking ring tabs with the second gear slots.
9. Install the first/second gear synchronizer assembly. Position the output shaft with the output end facing downward. Using the special tools, press the first/second gear synchronizer assembly into place.
- Install the synchronizer with the groove on the sleeve facing first gear.
- Stop press operation before keys engage the blocking ring slots. Lift and rotate the second gear and the blocking ring until the keys are seated in the blocking ring.
10. Install the first gear synchronizer thrust washer, the inner cone, the friction cone and the first gear synchronizer blocking ring.
11. Install a new snap ring.
12. Install the first gear needle bearing.
- Apply petroleum jelly to the bearing.
13. Install first gear.
- Rotate the gear to align the gear slots with the inner cone tabs.
14. Install a new rear output shaft bearing.
15. Using the special tools, install the fifth driven gear.
Disassembly
1. CAUTION: Hand tighten the special tool to prevent gear damage. CAUTION: Support the output shaft while using the press to prevent damage to the shaft or gears. Using the special tool and ...Countershaft
Special Tool(s) Plate, Bearing Oil Seal 205-090 (T75L-1165-B) Puller, Bearing 205-D064 (D84L-1123-A) Installer, Drive Pinion Bearing Cone 205-004 (T53T-4621- ...Other materials:
Water Pump - 4.6L(2V) and 4.6L(4V)
Material
Item
Specification
Motorcraft Premium Gold
Engine Coolant
VC-7-A (in Oregon VC-7-B)
(yellow color)
WSS-M97B51-
A1
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
...
Brake Caliper - Cobra
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper locating pin E-clip.
4. Remove the caliper locating pin.
5. Remove the front brake flow bolt.
6. Remove the caliper.
7. Remove the brake pa ...
The better business bureau (BBB) auto line program
(U.S. Only)
Your satisfaction is important to Ford Motor Company and to your dealer.
If a warranty concern has not been resolved using the three-step
procedure outlined earlier in this chapter in the Getting the Services
You Need section, you may be eligible to participa ...