Ford Mustang Service Manual: Assembly
Disassembly
1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section.
2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench, being careful not to damage the tube.
3. NOTE: If components are not marked and installed correctly, driveline imbalance can occur.
Index-mark the positions of the driveshaft components.
4. Clamp the U-joint tool in a vise.
5. Remove all four of the snap rings.
6. Remove the driveshaft flange yoke.
1. Position the driveshaft flange yoke in the U-joint tool.
2. Press out a bearing cup.
3. Remove the driveshaft flange yoke.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the driveshaft flange yoke.
7. Remove the spider.
1. Reposition the driveshaft in the U-joint tool.
2. Press out the bearing cup.
3. Rotate the driveshaft.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
Disassembly
Disassembly 1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section. 2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws ...Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
General Specifications a: In-vehicle repair refill capacities are determined by filling the rear axle with the specified lubricant to 6.4-14.3-mm (1/4-9/16-in) below the bottom of the fill hole. To ...Other materials:
Axle Housing Bushing
Rear Drive Axle and Differential
The axle housing assembly consists of a cast center section with two
steel tube assemblies and
a stamped differential housing cover (4033). The differential housing cover
uses silicone sealant
as a gasket.
...
Caliper
Master Cylinder Priming - In-Vehicle or Bench
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid
contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush
eyes with
running water for 15 minutes. Get medi ...
Glass, Frames and Mechanisms (Description and Operation)
Glass, Frames and Mechanisms (Description and Operation)
Component Location
Windshield Glass
The windshield exterior mouldings are installed with the windshield
glass. The windshield exterior
mouldings cannot be replaced without removal of the w ...