Ford Mustang (1999-2004) Service Manual: Assembly
1. CAUTION: Before beginning assembly, carry out and inspect the following: When building up subassemblies and assembling the transmission, ALWAYS use new gaskets and seals.
All fasteners must be tightened to the torque specification indicated. In addition to appearing in the section, the necessary torques can be found in the General Specifications Chart.
When building up subassemblies, each component part should be lubricated with clean transmission fluid. It is also good practice to lubricate the subassemblies as they are installed in the case.
Needle bearings, thrust washers and seals should be lightly coated with petroleum jelly during subassembly buildup or transmission assembly.
Many components and surfaces in the transmission are precision machined. Careful handling during disassembly, cleaning, inspection and assembly can prevent unnecessary damage to machined surfaces.
Install the valve body cover plate.
1. Position the valve body cover plate gasket and cover plate.
2. Install the two guide pin bolts.
3. Install the bolts.
2. Tighten the bolts in the sequence shown.
3. Install the eight coasting booster valve shuttle balls.
4. Install the converter drain back valve and solenoid pressure supply screen.
5. Install the separator plate and gaskets.
6. Install the two reinforcement plates.
1. Position the plates.
2. Install the bolts.
7. NOTE: Inspect the shift solenoid O-rings and TCC solenoid O-rings for damage.
Install the shift solenoid.
1. Position the TCC solenoid.
2. Position the shift solenoid.
3. Install the bolt.
Disassembly
Main Control Valve Body - Disassembled View 1. Remove the torque converter clutch (TCC) solenoid and the shift solenoid. 1. Remove the bolt. 2. Remove the shift solenoid. 3. Remov ...Pump and Intermediate Clutch Piston
Special Tool(s) Installer, Front Pump Fluid Seal 307-014 (T63L-77837-A) Protector, Piston Seal 307-339 (T95L-77005-A) Pump and Intermediate Clutch Piston - Disassembled ...Other materials:
Jacking
WARNING: Never run the engine with one wheel off the ground, such as
when changing a
tire. The wheel still on the ground could cause the vehicle to move.
CAUTION: The jack (17080) provided with the vehicle is intended to be
used in an
emergency for changing ...
Getting assistance outside the U.S. And Canada
Before exporting your vehicle to a foreign country, contact the
appropriate foreign embassy or consulate. These officials can inform you
of local vehicle registration regulations and where to find unleaded fuel.
If you cannot find unleaded fuel or can only ge ...
Pump and Intermediate Clutch Piston
Special Tool(s)
Installer, Front Pump Fluid
Seal
307-014 (T63L-77837-A)
Protector, Piston Seal
307-339 (T95L-77005-A)
Pump and Intermediate Clutch Piston - Disassembled View
...