Ford Mustang (2005-2014) Owners Manual: Autolamps

WARNING

: In severe weather conditions, it may be necessary to switch your headlamps on manually.

Note

: If the vehicle is equipped with autolamps, it will have the windshield wiper rainlamp feature. When the windshield wipers are turned to low- or high-speed wiping during daylight, and the headlamp control is in the autolamp position, the exterior lamps will turn on after a brief delay and will remain on until the wipers are turned off.

The autolamp system provides light sensitive automatic on-off control of the


The autolamp system provides light sensitive automatic on-off control of the exterior lights normally controlled by the headlamp control.

The headlamps will remain on for a period of time after you switch the ignition off. You can adjust the time delay using the display controls in the instrument cluster. See the Information Displays chapter.

    Lighting control
    A. Off B. Parking lamps, instrument panel lamps, license plate lamps and tail lamps C. Headlamps High Beams • Push the lever toward the instrument panel to switch on the high beams. • Pull th ...

    Instrument lighting dimmer
    • Move the control up or down to adjust the intensity of the panel lighting. • Move the control to the full upright position, past detent, to turn on the interior lamps. • Move the control down, ...

    Other materials:

    Analysis of Vibration
    Inspection and Verification Certain axle noise or vibration symptoms are also common to the engine, transmission, wheel bearings, tires, and other parts of the vehicle. For this reason, be sure that the cause of the trouble is in the axle before disassemblin ...

    NVH Condition and Symptom Categories
    Road Test NOTE: It may be necessary to have the customer ride along or drive the vehicle to point out the concern. During the road test, take into consideration the customer's driving habits and the driving conditions. The customer's concern just may be an a ...

    Installation
    Removal CAUTION: Since the engine is not free-wheeling, if the crankshaft or the camshafts are moved in any manner during removal and installation, the crankshaft and the camshafts must be re-synchronized. 1. Remove the engine front cover. For additional in ...