Ford Mustang (1999-2004) Service Manual: Brake Caliper Anchor Plate - Cobra
Removal
1. Remove the pads. For additional information, refer to Brake Pads-Cobra in this section.
2. Remove the anchor plate bolts.
Installation
1. Follow the removal procedure in reverse order.
Brake Caliper - Cobra
Removal 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. Remove the caliper locating pin E-clip. 4. Remove the caliper locating pin. 5. Remove the front brake ...Brake Caliper Anchor Plate
Removal 1. Remove the pads. For additional information, refer to Pads in this section. 2. Remove the anchor plate (2B292). 1. Remove and discard the anchor plate bolts. 2. Remove the ...Other materials:
Component Tests
Driveline Vibration
An analysis of driveline vibration can also be conducted using the Vibration
Analyzer; follow the
manufacturer's directions.
Driveline vibration exhibits a higher frequency and lower amplitude than does
high-speed shake.
Driveline vibra ...
Accessory Drive Belt - 4.6L (2V) and (4V)
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
4. Remov ...
Installation
1. CAUTION: Lubricate the filler pipe check valve area and the
tank-to-filler pipe
grommet with Serfactant prior to assembly or damage to the filler pipe check
valve will
occur.
NOTE: A new grommet must be used for the installation procedure due to
its dest ...