Ford Mustang (1999-2004) Service Manual: Brake Shift Interlock Actuator
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the electrical connector.
6. CAUTION: Extra force may be needed to lift up on the handle. Do not to pull too far or damage to the overdrive cancel button may result, as the wires may be pulled out of the switch.
Remove the screw and the handle.
7. Remove the clip and bolt from the brake shift interlock cable.
8. Disconnect the shift interlock cable.
9. Remove the instrument panel steering column cover.
1. Remove the screws.
2. Remove the instrument panel steering column cover.
10. Remove the instrument panel reinforcement.
1. Remove the screws.
2. Remove the instrument panel reinforcement.
11. Remove the nuts and lower the steering column.
12. Remove the screws from the brake shift interlock cable.
13. Remove the brake shift cable interlock actuator.
Installation
1. To install, reverse the removal procedure.
Cable Adjustment
1. NOTE: Make sure that the range selector lever is tight against the rearward overdrive stop. Place the transmission range selector lever in the overdrive position. 2. Raise and support the ...Cable and Bracket
Removal 1. Raise the vehicle on a hoist. For additional information, refer to Section. 2. Remove the cable shift from the shifter lever and bracket and discard the clip. 3. Remove the bol ...Other materials:
Climate Control System (Description and Operation)
WARNING: To avoid accidental deployment and possible injury, the air
bag system
backup power supply must be depleted before repairing any climate control
components. To
deplete the backup power supply, disconnect the battery ground cable and wait
one minute ...
Glass, Frames and Mechanisms
WINDOW REGULATOR ELECTRIC DRIVE
CURRENT DRAW
General Specifications
Torque Specifications
...
Cleaning the engine
Engines are more efficient when they are clean because grease and dirt
buildup keep the engine warmer than normal.
When washing:
• Take care when using a power washer to clean the engine. The
high-pressure fluid could penetrate the sealed parts and cause
da ...