Ford Mustang (1999-2004) Service Manual: Bumpers
Torque Specifications
Bumpers
CAUTION: Never apply excessive heat to the bumper cover surface. Heat could cause distortion of the bumper cover.
The bumper systems consist of the following components:
- front bumper
- front bumper cover
- front bumper cover (Cobra)
- front bumper isolator
- rear bumper
- rear bumper brace
- rear bumper cover
- rear bumper cover (Cobra)
- rear bumper isolator
Installation
Lift cylinder 1. NOTE: Be sure that each fitting is installed in the correct position on the folding top hydraulic component. NOTE: Make sure that the tetra seal is installed in the bottom of each of ...Front Bumper Cover
Removal and Installation NOTE: Mustang shown, GT and Cobra similar. 1. Remove the pin-type retainers and the radiator upper sight shield. 2. Remove the two pin-type retainers (one each side). 3. R ...Other materials:
Principles of Operation
Key-In-Ignition Warning Chime
The key-in-ignition warning chime activates when the generic
electronic module (GEM) detects the
ignition switch circuits are in the OFF or ACC states and when the GEM
detects the driver door is ajar
from the driver do ...
Fuel Line Fittings - Push Connect
Special Tool(s)
Disconnect Tool, Spring Lock
Coupling
310-S039 (T90T-9550-S)
Material
Item
Specification
SAE 5W-20 Super Premium
Blend Motor Oil
XO-5W20-QSP or equivalent
WSS-M2C153-
H
Disconnect
WARNING: Do not smoke ...
Apply Components
There are eight apply components used to drive or hold the planetary
gearset components.
Band-Overdrive
1. The overdrive band holds the reverse clutch drum stationary in fourth gear
and manual
2. This action
causes the reverse sun gear to be h ...