Ford Mustang (1999-2004) Service Manual: Cable Adjustment
1. NOTE: Make sure that the range selector lever is tight against the rearward overdrive stop.
Place the transmission range selector lever in the overdrive position.
2. Raise and support the vehicle. For additional information, refer to Section.
3. Loosen the manual control lever nut.
4. Place the transmission manual control lever in the overdrive position.
5. Tighten the nut on the manual control lever.
External Controls (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 37 , Shift Lock for schematic and connector information. Refer to Wiring Diagrams Cell 29 , Transmission Control for schematic and connector information. Special Tool(s ...Brake Shift Interlock Actuator
Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the electrical connect ...Other materials:
Accelerator Cable - 3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating ...
Pinpoint Tests
CAUTION: Do not make jumper connections except as directed.
Incorrect connections
may damage the voltage regulator test terminals, fuses, or fuse links.
CAUTION: Do not allow any metal object to come in contact with the
generator housing
and inter ...
Throttle Body
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
and can ignite. Failure to follow these instructions can resul ...