Ford Mustang (1999-2004) Service Manual: Camshaft Position (CMP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the camshaft position (CMP) sensor.
- Disconnect the connector.
- Remove the bolts and the sensor.
Installation
1. To install, reverse the removal procedure.
Temperature and Manifold Absolute Pressure (T-MAP) Sensor - Cobra
Removal and Installation 1. Disconnect the temperature manifold absolute pressure (T-MAP) sensor electrical connector. 2. Remove the bolts and the T-MAP sensor. 3. To install, reverse the rem ...Camshaft Position (CMP) Sensor - 4.6L
Removal and Installation 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the bolts and position aside the power steering pump reservoir. 3. ...Other materials:
Engine (Installation)
Special Tool(s)
Lifting Bracket, Engine
303-D087 (D93P-6001-A1)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Installer Set, Teflon Seal
211-D027 (D90P-3517A) or
equivalent
Spreader Bar
303-D089 (D9 ...
Anti-Lock Control - Traction Control
Torque Specifications
Anti-Lock Control -Traction Control
The four wheel anti-lock brake system (4WABS) with traction control consists
of the following
components:
anti-lock brake control module (2C346)
front anti-lock brake sensor (2C204)/(2C205)
front ...
Reservoir
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols.
Avoid contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes,
flush eyes with
running water for 15 minutes. Get medical attention if irritation persi ...