Ford Mustang (1999-2004) Service Manual: Camshaft Position (CMP) Sensor - 4.6L
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the bolts and position aside the power steering pump reservoir.
3. Remove the camshaft position (CMP) sensor.
- Disconnect the connector.
- Remove the bolt and the sensor.
4. To install, reverse the removal procedure.
Camshaft Position (CMP) Sensor - 3.8L
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the camshaft position (CMP) sensor. Disconnect the connector. Remove the bolts ...Intake Manifold Runner Control (IMRC) Actuator - 3.8L
Removal and Installation 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Drain the cooling system. For additional information, refer to Section. ...Other materials:
Engine Coolant Temperature (ECT) Sensor - Mach I
Material
Item
Specification
Pipe Sealant with Teflon
D8AZ-19554-A
WSK-M2G350-A2
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to
Section.
2. Partially drain the engine cooling system. For ...
Starting a gasoline engine
When you start the engine, the idle speed increases, this helps to warm
up the engine. If the engine idle speed does not slow down automatically,
have your vehicle checked by an authorized dealer.
Before starting the engine:
• Make sure all occupants have f ...
Component Tests
Brake Booster
1. Check the hydraulic brake system for leaks or insufficient fluid.
2. With the transmission (7003) in NEUTRAL, stop the engine (6007) and
apply the parking brake
control (2780). Apply the brake pedal several times to exhaust all
va ...