Ford Mustang (1999-2004) Service Manual: Camshaft Roller Follower

Special Tool(s)

Compressor, Valve Spring (Intake) 303-452 (T93P-6565-AR)
Compressor, Valve Spring (Exhaust) 303-567 (T97P-6565-AH)

Removal

1. Remove the valve cover. For additional information, refer to Valve Cover LH or Valve Cover RH in this section.

2. Position the piston of the cylinder being serviced at the bottom of the stroke and the camshaft lobe at base circle.

3. Using the special tool compress the intake valve spring.

Camshaft Roller Follower

4. Remove the roller follower from the intake valve.

Camshaft Roller Follower

5. Using the special tool compress the exhaust valve spring.

Camshaft Roller Follower

6. Remove the camshaft roller follower from the exhaust valve.

Camshaft Roller Follower

7. Repeat Steps 2, 3 and 4 to remove all the necessary roller followers. Inspect roller finger followers and camshafts. For additional information, refer to Section.

Installation

1. To install, reverse the removal procedure.

    Hydraulic Lash Adjuster
    Removal and Installation 1. Remove the roller followers. For additional information, refer to Camshaft Roller Follower in this section. 2. Remove the eight hydraulic lash adjusters. 3. Inspect the ...

    Camshaft
    Removal and Installation 1. Remove the timing chains. For additional information, refer to Timing Drive Components in this section. 2. Remove the roller followers. For additional information, refer ...

    Other materials:

    Output State Control (OSC) Mode
    Output State Control (OSC) allows the technician to take control of certain parameters to function the transmission. For example, OSC allows the technician to shift the transmission only when he/she commands a gear change. If the technician commands ...

    Camber and Caster Adjustment - Front
    All vehicles 1. Remove the rivet. Loosen the nuts and bolt. Vehicles requiring camber adjustment 2. Move the front suspension camber adjusting plate (3B391) to the required camber setting. Vehicles requiring caster adjustment 3. NOTE: If caster adjustment ...

    Engine (Removal)
    Special Tool(s) Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) or equivalent Spreader Bar 303-D089 (D93P-6001-A3) or equivalent Heavy Duty Floor Crane 014-00071 or equivalent Removal WARNING: Do not smoke or ...