Ford Mustang Service Manual: Catalyst Monitor Sensor

Electronic Engine Controls (Description and Operation)

The electronic engine controls consist of the following:

  • powertrain control module (PCM)
  • throttle position (TP) sensor
  • idle air control (IAC) valve
  • engine coolant temperature (ECT) sensor
  • cylinder head temperature sensor
  • camshaft position (CMP) sensor
  • crankshaft position (CKP) sensor
  • mass air flow (MAF) sensor
  • intake air temperature (IAT) sensor
  • heated oxygen sensor (HO2S) - front
  • catalyst monitor sensor - rear
  • wheel speed sensor

The powertrain control module needs the following inputs to calibrate the engine correctly:

  • crankshaft position
  • engine rpm
  • engine load (manifold pressure)
  • atmospheric (barometric) pressure
  • engine coolant temperature

The throttle position sensor:

  • sends the powertrain control module a signal indicating the throttle plate angle.
  • is the main input to the powertrain control module from the driver.

The idle air control valve:

  • controls bypass air around the throttle plate at low speeds.
  • is controlled by the powertrain control module.

The cylinder head temperature sensor:

  • provides a gauge signal for coolant temperature.
  • is mounted on rear of LH cylinder head.
  • sends the powertrain control module a signal indicating engine temperature.
  • resistance decreases as coolant temperature increases.

The camshaft position sensor:

  • sends the powertrain control module a signal indicating camshaft position, used for fuel synchronization.

The crankshaft position sensor:

  • sends the powertrain control module a signal indicating crankshaft position.
  • is essential for calculating spark timing.

The mass air flow sensor:

  • sends the powertrain control module a signal indicating mass air flow rate of air entering the engine.

The intake air temperature sensor:

  • sends the powertrain control module a signal indicating the temperature of the air entering the engine.

The heated oxygen sensor:

  • has the ability to create a voltage signal depending on exhaust oxygen content.
  • provides feedback information to the powertrain control module used to calculate fuel delivery.

The rear catalyst monitor sensor:

  • monitors oxygen content after the oxygen flows through the catalytic converter.
  • provides a voltage to the powertrain control module used to calculate catalytic converter integrity.

The wheel speed sensor:

  • sends a signal to the powertrain control module indicating wheel speed.
    Heated Oxygen Sensor (HO2S)
    Electronic Engine Controls (Description and Operation) The electronic engine controls consist of the following: powertrain control module (PCM) throttle position (TP) sensor idle air contr ...

    Clutch Pedal Position (CPP) Switch
    Electronic Engine Controls (Description and Operation) The electronic engine controls consist of the following: powertrain control module (PCM) throttle position (TP) sensor idle air contr ...

    Other materials:

    Torque Converter Cleaning And Inspection
    Transmission Description (Description and Operation) The 4R70W has the following features: Wide ratio gears Four speeds Rear wheel drive Automatic Electronic shift Torque converter clutch control Line pressure controls The transm ...

    Crankshaft Rear Seal
    Engine Component View Cylinder Heads and Valve Train Components   Engine Front Cover Components   Engine Components   Cylinder Block and Lower End Components   Engine (DIAGNOSIS AND TESTING) Refer to Section for basic mecha ...

    Power windows
    WARNING: Do not leave children unattended in your vehicle and do not let children play with the power windows. They may seriously injure themselves. WARNING: When closing the power windows, you should verify they are free of obstructions and make sure tha ...