Ford Mustang (2005-2014) Owners Manual: Cleaning the engine

Engines are more efficient when they are clean because grease and dirt buildup keep the engine warmer than normal.

When washing:

• Take care when using a power washer to clean the engine. The high-pressure fluid could penetrate the sealed parts and cause damage.
• Do not spray a hot engine with cold water to avoid cracking the engine block or other engine components.
• Spray Motorcraft® Engine Shampoo and Degreaser on all parts that require cleaning and pressure rinse clean. In Canada, use Motorcraft® Engine Shampoo.
• Never wash or rinse the engine while it is hot or running; water in the running engine may cause internal damage.
• Never wash or rinse any ignition coil, spark plug wire or spark plug well, or the area in and around these locations.
• Cover the battery, power distribution box, and air filter assembly to prevent water damage when cleaning the engine.

    Repairing minor paint damage
    Your authorized dealer has touch-up paint to match your vehicle’s color. Take your color code (printed on a sticker in the driver’s door jamb) to an authorized dealer to make sure you get the cor ...

    Cleaning the windows and wiper blades
    The windows and wiper blades should be cleaned regularly. If the wipers do not wipe properly, substances on the vehicle’s glass or the wiper blades may be the cause. These may include hot wax treatm ...

    Other materials:

    Hydraulic Control Unit
    Removal 1. Disconnect the battery ground cable(14301). 2. Disconnect the anti-lock-brake control module electrical connector. 3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction control is shown , the 4WABS without traction control system is ...

    Brake Booster - Hydro-Boost (Removal and Installation)
    Special Tool(s) Installer Set, Teflon Seal 211-D027 (D90P-3517-A) or equivalent Removal WARNING: The power brake booster should not be carried by the accumulator, nor should it ever be dropped on the accumulator. Check the snap ring on th ...

    Assembly
    1. NOTE: One tab that locks the reverse clutch drum into the reverse sun shell may be removed. This is done for balancing purposes. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate serrations for scores or burrs. Minor scores or bu ...