Ford Mustang (1999-2004) Service Manual: Clutch Pedal Position (CPP) Switch
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Disconnect the connector.
3. Remove the bolt and the clutch pedal position (CPP) switch.
Installation
1. To install, reverse the removal procedure.
Catalyst Monitor Sensor
Special Tool(s) Socket, Exhaust Gas Oxygen Sensor 303-476 (T94P-9472-A) Material Item Specification Penetrating and Lock Lubricant or equivalent E8AZ-19A501- B ...Fuel Pressure Sensor
Material Item Specification Super Premium SAE 5W-20 Motor Oil XO-5W20-DSP or equivalent WSS-M2C914- A Removal WARNING: Do not smoke or carry lighted tobacco or open flame of ...Other materials:
Refrigerant Oil Adding
CAUTION: During normal A/C operation, oil is circulated through the
system with the
refrigerant, and a small amount is retained in each component. If certain
components of the
system are removed for new installation, some of the refrigerant oil will go
with ...
Lumbar Motor
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Disconnect the power seat track electrical connector.
3. Remove the four seat track bolts.
Vehicles with standar ...
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive
discs or other
abrasive means to clean the sealing surfaces. These tools cause scratches and
gouges
which make leak paths. Use a plastic scraping tool to remove all traces of old
sealant.
...