Ford Mustang (1999-2004) Service Manual: Clutch Pedal - Quadrant and Pawl Assembly
Removal
1. Disconnect the battery ground cable (14301).
2. Loosen the nut from inside the engine compartment.
3. Loosen the nuts from inside the vehicle.
4. Loosen the screw.
5. Disconnect the brake pedal position (BPP) switch electrical connector.
6. Disconnect the brake pedal-to-power brake booster push rod.
1. Remove the self-locking pin.
2. Remove the BPP switch from the brake master cylinder push rod.
3. Remove the brake master cylinder push rod spacers (2B129).
4. Remove the brake master cylinder push rod bushing (2474).
7. Disconnect the clutch pedal position (CPP) switch electrical connector.
8. Disconnect the deactivation switch connector from the wiring harness.
9. WARNING: Do not allow the quadrant to snap rearward. Failure to follow this instruction may result in personal injury.
NOTE: Lift the clutch pedal all the way up to release the clutch release lever cable (7K553).
Rotate the clutch pedal adjuster quandrant (7L583) and unhook the clutch release lever cable (7K553).
10. Remove the nuts.
11. Remove the screw.
12. Remove the nut and the clutch pedal (7519).
13. Remove the self-adjusting mechanism.
14. Remove the self-adjusting mechanism shaft bushings.
Installation
1. NOTE: Before the installation of the clutch pedal shaft or clutch pedal, remove and inspect the brake and clutch pedal bushings. Clean and lubricate with a light film of engine oil meeting Ford specification WSS-M2C153-G and replace the brake and clutch pedal bushing if excessive wear is evident.
To install, reverse the removal procedure.
Clutch Controls (Description and Operation)
The clutch control system engages and disengages the clutch. The clutch control system disengages the clutch when the clutch pedal is depressed and engages the clutch when the clutch pe ...Release Cable - Clutch
Removal CAUTION: Whenever the clutch release lever cable (7K553) is disconnected for any reason, such as transmission removal, clutch pedal components or clutch release lever cable replacement, ...Other materials:
Axle
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Adapter for 205-S127
205-105 (T76P-4020-A3)
Bearing Preload Tool
205-395 (T93P-4220-A)
Plate, Bearing/Oil Seal
205-090 (T75L-1165-B)
Gauge, ...
Driveline Angle Inspection
Special Tool(s)
Anglemaster II Driveline
Inclinometer
164-R2402 or equivalent
NOTE: An incorrect driveline angle can cause a vibration or shudder.
1. Check the vehicle for evidence or overload or sagging. Check for specified
air pressures
in ...
Removal
1. Remove brake master cylinder filler cap (2162). Check brake fluid
level in brake master cylinder
reservoir (2K478). Remove fluid until brake master cylinder reservoir is
half full.
2. Raise and support the vehicle.
3. Remove the wheel and ...