Ford Mustang (1999-2004) Service Manual: Communication Circuit Wiring Repair
Special Tool(s)
Heat Gun 107-R0300 or equivalent |
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Strip the wires.
3. NOTE: Use rosin core mildly activated (RMA) solder, not acid core solder.
Solder the wires.
1. Install the heat shrink tube.
2. Twist the wires together.
3. Solder the wires together.
4. NOTE: Wait for the solder to cool before moving the wires.
Bend the wires back in a straight line.
5. Position the (A) heat shrink tube over the (B) wire repair.
- Overlap the heat shrink tube on both wires.
6. Use the heat gun to heat the repaired area until adhesive flows out both ends of the heat shrink tube.
7. Reconnect the battery ground cable.
Pinpoint Tests
CAUTION: Be careful when probing the CJB, battery junction box (BJB) or any connectors. Damage will result to the connector receptacle if the probe or terminal being used is too large. CAUTION ...Module Configuration
Module Configuration (Diagnosis and Testing) Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224 New Generation STAR (NGS) Tester 418-F052 or equivalent diagnostic tool ...Other materials:
Installation
1. Position the wiring harness:
Install the wiring harness retainer onto the LH valve cover stud bolt.
Install the wiring harness retainer into the power steering reservoir.
2. Connect the ECT sensor electrical connector.
3. Connect the CMP senso ...
Stoplamps
Refer to Wiring Diagrams Cell 90 , Turn/Stop/Hazard Lamps for
schematic and connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
1. Verify the customer concerns.
2. Visually ...
Brake Booster - Vacuum (Description and Operation)
Power Brake Booster
The vacuum type power brake booster (2005):
is a dual diaphragm, vacuum assisted power brake booster
reduces brake pedal force and travel distance.
is located on the LH side of the bulkhead in the engine compartment,
be ...