Ford Mustang (1999-2004) Service Manual: Condenser to Evaporator Line
Material
Item | Specification |
PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) | WSH-M1C231- B |
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant. For additional information, refer to Section.
2. Remove the air cleaner outlet tube. For additional information, refer to Section.
3. Raise the vehicle. For additional information, refer to Section.
4. Remove the line bracket pin-type retainer.
5. Lower the vehicle.
6. Remove the nut and disconnect the fitting at the condenser.
- Discard the O-ring seal.
7. Disconnect the spring lock coupling at the evaporator core.
- Discard the O-ring seals.
8. Remove the condenser to evaporator line.
9. To install, reverse the removal procedure.
- Install new O-ring seals lubricated in clean PAG oil.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.
Compressor to Condenser Discharge Line - 4.6L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a ...Other materials:
Disassembly
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. Remove the bolts.
3. CAUTION: Do not damage the threads in the bolt holes.
Insert a punch in the bolt holes and d ...
General information
WARNING: Driving while distracted can result in loss of vehicle
control, accident and injury. Ford strongly recommends that drivers
use extreme caution when using any device or feature that may take their
focus off the road. Your primary responsibility is the ...
Exhaust Manifold LH
Removal and Installation
1. Position the steering wheel straight ahead and lock the column.
2. Disconnect the battery ground cable. For additional information, refer to
Section.
3. Raise the vehicle. For additional information, refer to Section.
4. Remove ...