Ford Mustang (1999-2004) Service Manual: Connecting Rod - Bushing Diameter
1. Measure the inner diameter of the connecting rod bushing, if equipped. Verify the diameter is within specification.
- Refer to the appropriate section in Group for the procedure.
- If out of specification, install new components as necessary. Refer to the appropriate section in Group for the procedure.
Connecting Rod -Bend
1. Measure the connecting rod bend on a suitable alignment fixture. Follow the instructions of the fixture manufacturer. Verify the bend measurement is within specification.
- Refer to the appropriate section in Group for the procedure.
- If out of specification, install new components as necessary. Refer to the appropriate section in Group for the procedure
Piston - Pin Diameter
1. Measure the piston pin diameter in two directions at the points shown. Verify the diameter is within specification. Refer to the appropriate section in Group for the procedure. If out of s ...Connecting Rod - Twist
1. Measure the connecting rod twist on a suitable alignment fixture. Follow the instructions of the fixture manufacturer. Verify the measurement is within specification. Refer to the appropriat ...Other materials:
Valve Spring Strength
Special Tool(s)
Pressure Gauge, Valve/Clutch
Spring
303-006 (TOOL-6513-DD) or
equivalent
1. Use a Valve/Clutch Spring Pressure Gauge to check the valve spring for
correct strength at the
specified valve spring length.
Refer to the appr ...
Actuator - Door Lock
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the door latch (21812). For additional information, refer to
Latch-Door .
3. Remove the door ajar switch.
Release the locking tab.
4 ...
Clutch Controls (Description and Operation)
The clutch control system engages and disengages the clutch. The clutch
control system disengages
the clutch when the clutch pedal is depressed and engages the clutch when the
clutch pedal is
released. Clutch pedal motion is transmitted by the c ...