Ford Mustang (1999-2004) Service Manual: Cooler - Fluid
Removal
1. Raise and support the vehicle.
2. Disconnect the power steering hoses.
3. Remove the bolt and routing bracket.
4. Remove the bolts and the power steering fluid cooler.
Installation
1. To install, reverse the removal procedure.
2. Fill and leak check the power steering system.
Hose
Special Tool(s) Installer Set, Teflon Seal 211-D027 (D90P-3517-A) or equivalent Removal and Installation CAUTION: While servicing the power steering system, make sure to plug all op ...Gear (Removal and Installation)
Special Tool(s) Teflon Seal Replacer Set 211-D027 (D90P-3517-A) or Equivalent Tie Rod End Remover 211-001 (TOOL-3290-D) Removal 1. Turn the steering wheel as necessary to pos ...Other materials:
Accelerator Cable - 3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating ...
Air Cleaner Outlet Pipe - 3.8L
Removal and Installation
1. Remove the air cleaner outlet tube.
1. Loosen the clamps.
2. Disconnect the hose.
3. Remove the tube.
2. To install, reverse the removal procedure.
Air Cleaner Outlet Pipe -4.6L (2V)
Removal and Installation
1. Dis ...
Cable and Bracket
Removal
1. Raise the vehicle on a hoist. For additional information, refer to
Section.
2. Remove the cable shift from the shifter lever and bracket and discard
the clip.
3. Remove the bolt from the cable.
4. Remove the bolt from the cable.
5. ...