Ford Mustang (1999-2004) Service Manual: Countershaft Bearing
Special Tool(s)
Remover, Drive Pinion Bearing Cone 205-D002 (D79L-4621-A) or equivalent | |
Installer, Drive Pinion Bearing Cone 205-011 (T57L-4621-B) |
Disassembly and Assembly
1. Cut the outer cage, then remove the outer cage and rollers.
2. Using the special tool and a press, remove the inner bearing.
3. Using the special tools, install the new countershaft bearing.
Assembly
1. Carry out the following before reassembling: Inspect the gears for broken or cracked teeth. Check for unusual wear patterns. Inspect the thrust washers for face wear, cracks, scoring and for s ...Synchronizers
Disassembly and Assembly NOTE: This procedure applies to all synchronizer assemblies. 1. Scribe an alignment mark on the sliding sleeve and the hub for assembly reference. 2. Remove the sliding sleev ...Other materials:
Exterior mirrors
Power Exterior Mirrors
WARNING: Do not adjust the mirror while your vehicle is in
motion.
A. Left mirror
B. Off
C. Right mirror
To adjust your mirrors:
1. Select the mirror you want to adjust.
2. Move the control in the direction you want to tilt the mirror.
...
Lumbar Assembly
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Release the J-clip.
3. Remove the seat backrest latch handle knob (62762).
4. Pull the seat backrest trim cover ...
Installation
WARNING: To reduce the risk of serious personal injury, read
and follow all warnings,
cautions and notes at the beginning of the removal procedure.
1. Install the passenger air bag module.
1. Position the passenger air bag module into the instrume ...