Ford Mustang (1999-2004) Service Manual: Crankshaft Position (CKP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the crankshaft position (CKP) sensor.
- Disconnect the connector.
- Remove the bolts and the sensor.
Installation
1. To install, reverse the removal procedure.
Intake Manifold Runner Control (IMRC) Actuator - 3.8L
Removal and Installation 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Drain the cooling system. For additional information, refer to Section. ...Crankshaft Position (CKP) Sensor - 4.6L
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the A/C compressor. For additional information, refer to Section. 3. Remove the cr ...Other materials:
Handle - Interior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the rivet.
3. Remove the cable clip.
4. Release the cable housing from the interior handle.
5. Release the actuating cable from the interior ha ...
Suction Accumulator
NOTE: Installation of a new suction accumulator is not required when
repairing the air conditioning
system except when there is physical evidence of contamination from a failed A/C
compressor or
damage to the suction accumulator.
In addition to th ...
Ordering additional owner’s literature
To order the publications in this portfolio, contact Helm, Incorporated at:
HELM, INCORPORATED
47911 Halyard Drive
Plymouth, Michigan 48170
Attention: Customer Service
Or to order a free publication catalog, call toll free: 1-800-782-4356
Monday-Friday 8:00 a. ...