Ford Mustang (1999-2004) Service Manual: Crankshaft Pulley
Special Tool(s)
Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) | |
Remover, Crankshaft Vibration Damper 303-176 (T82L-6316-B) | |
Installer, Crankshaft Damper/Crankshaft Front Oil Seal 303-175 (T82L-6316-A) |
Material
Removal
1. Remove the drive belt (8620). For additional information, refer to Section.
2. Remove the radiator coolant recovery reservoir (8A080).
3. Raise the vehicle on a hoist. For additional information, refer to Section.
4. Remove the crankshaft pulley bolt.
5. Using the special tool, remove the crankshaft pulley (6B321).
Installation
1. Apply a bead of silicone gasket and sealant to the keyway in the crankshaft damper and use the special tool to install the crankshaft pulley.
2. Install the crankshaft bolt.
3. Lower the vehicle.
4. Install the radiator coolant recovery reservoir.
5. Install the drive belt. For additional information, refer to Section.
Valve Cover RH
Removal and Installation 1. Remove the throttle body. For additional information, refer to Section. 2. Disconnect the crankcase vent hose. 3. Remove the differential feedback exhaust gas recirc ...Crankshaft Front Seal
Special Tool(s) Installer, Front Cover Oil Seal 303-335 (T88T-6701-A) Installer, Crankshaft Front Oil Seal 303-474 (T94P-6701-AH) Remover, Oil Seal 303-409 (T92C-6700 ...Other materials:
Switch - Horn
Removal
1. Remove the driver side air bag module (043B13). Refer to Section.
2. Remove the switches.
1. Disconnect the horn wire from the switches.
2. Remove the horn switch screws and remove the switches.
Installation
1. To install, reve ...
Trailer towing
WARNING: Do not exceed the GVWR or the GAWR specified on
the certification label.
WARNING: Towing trailers beyond the maximum recommended
gross trailer weight exceeds the limit of your vehicle and could
result in engine damage, transmission damage, structural ...
Component Tests
Pressure Test
1. Turn the engine OFF.
2. WARNING: Never remove the pressure relief cap under any conditions
while the
engine is operating. Failure to follow these instructions could result in damage
to the
cooling system or engine and/or personal injury. To ...