Ford Mustang (1999-2004) Service Manual: Crankshaft Pulley
Special Tool(s)
Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) | |
Installer, Crankshaft Vibration Damper 303-102 (T74P-6316-B) |
Material
Item | Specification |
Silicone Gasket and Sealant F7AZ-19554-EA or equivalent | WSE-M4G323-A4 |
Removal
1. Remove the drive belt. For additional information, refer to Section.
2. Raise and support the vehicle. For additional information, refer to Section.
3. Remove the bolt.
4. Using the special tool, remove the crankshaft pulley (6312).
Installation
1. NOTE: The crankshaft pulley must be installed within four minutes of applying the sealant.
Apply sealant to the woodruff key slot on the crankshaft pulley.
2. Using the special tool, install the crankshaft pulley.
3. Install the washer and the bolt. Tighten the bolt in four stages.
- Stage 1: Tighten the bolt to 90 Nm (66 lb-ft).
- Stage 2: Loosen the bolt one full turn.
- Stage 3: Tighten the bolt to 50 Nm (37 lb-ft).
- Stage 4: Tighten the bolt an additional 90 degrees.
4. Lower the vehicle.
5. Install the drive belt. For additional information, refer to Section.
Valve Cover LH
Material Item Specification Silicone Gasket and Sealant F7AZ-19554-EA or equivalent WSE-M4G323-A4 Removal and Installation 1. Position the oil level tube (6754) out of the way. 2 ...Crankshaft Front Oil Seal
Special Tool(s) Crankshaft Seal Installer/Aligner 303-335 (T88T-6701-A) Front Cover Seal Remover 303-107 (T74P-6700-A) Crankshaft Seal Installer 303-635 ...Other materials:
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive
discs or other
abrasive means to clean the sealing surfaces. These tools cause scratches and
gouges
which make leak paths. Use a plastic scraping tool to remove all traces of old
sealant.
...
Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw.
5. Release the clips.
1. Lift up to release the two ...
Functionality
With the ignition switch in the RUN position, voltage is applied
through the warning indicator I circuit
904 (LG/RD) to the voltage regulator. This turns the regulator on,
allowing current to flow from battery
sense A circuit 36 (YE/WH) to the genera ...