Ford Mustang (1999-2004) Service Manual: Cylinder Head - Distortion
Special Tool(s)
Straight Edge 303-D039 (D83L-4201-A) or equivalent |
1. Use a straight edge and a feeler gauge to inspect the cylinder head for flatness. If the cylinder head is distorted, install a new cylinder head.
Cylinder Bore -Cleaning
1. CAUTION: If these procedures are not followed, rusting of the cylinder bores may occur.
Clean the cylinder bores with soap or detergent and water.
2. Thoroughly rinse with clean water and wipe dry with a clean, lint-free cloth.
3. Use a clean, lint-free cloth and lubricate the cylinder bores.
- Use clean engine oil meeting Ford specification.
Valve - Seat Inspection
Valve and Seat Refacing Measurements CAUTION: After grinding valves or valve seats, check valve clearance. 1. Check the valve head and seat. Check valve angles. Check margin width. Refer t ...Cylinder Block Core Plug Replacement
Special Tool(s) Slide Hammer 100-001 (T50T-100-A) Material 1. Use a slide hammer or tools suitable to remove the cylinder block core plug. 2. Inspect the cylinder block plug bore f ...Other materials:
Ignition Switch Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release
...
Inspection and Verification
1. Verify the customer's concern by operating the climate control system
to duplicate the condition.
2. Inspect to determine if one of the following mechanical or electrical
concerns apply:
Visual Inspection Chart
Mechanical
Electrical
...
Symptom Chart
Condition
Possible Sources
Action
Incorrect/erratic direction
of airflow from outlet(s)
No vacuum to A/C heater
function switch selector.
A/C heater function selector
switch leaks vacuum.
Kinked/pinched vacuu ...