Ford Mustang (1999-2004) Service Manual: Differential Case and Ring Gear - Traction-Lok
Special Tool(s)
 |
2-Jaw Puller 205-D072 (D97L-4221-A) or equivalent |
 |
Gauge, Differential Clutch 205-022 (T66L-4204-A) |
 |
Gauge, Differential Clutch 205-135 (T80P-4946-A) |
 |
Installer, Differential Side Bearing 205-010 (T57L-4221-A2) |
 |
Step Plate 205-D061 (D83T-4205-C2) or equivalent |
Assembly
1. Lubricate the differential side gear thrust washers and the differential
side gear journals, and
assemble the washers to the gears.
Use SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-1958 ...
Disassembly
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. Remove the 10 bolts.
3. CAUTION: Do not damage the thr ...
Other materials:
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolts, the IAC valve and the gasket.
4. NOTE: Install a new ga ...
Spark Plugs
Removal and Installation
1. Remove the ignition coil-on-plug. For additional information, refer to
Ignition Coil-On-Plug in this
section.
2. NOTE: Use compressed air to remove any foreign material from the
spark plug well before
removing the spark plu ...
Disassembly
1. Remove the No. 1 selective pump support thrust washer.
2. Remove the front pump support.
1. Remove the bolts.
2. Remove the front pump support.
3. Remove the seal rings.
4. Remove the inner and outer pump gerotor gears.
5. Carefully pry spring ...
